Answers
May 23, 2017 - 12:24 PM
The user manual states:
Not for computer (ECM) INPUT circuits. This tool has been tested successfully and will test computer (ECM) sensor driver circuits (B+ and Gnd/Return).
Link to User Manual
Not for computer (ECM) INPUT circuits. This tool has been tested successfully and will test computer (ECM) sensor driver circuits (B+ and Gnd/Return).
Link to User Manual
Source: Staff
May 30, 2017 - 06:03 AM
That response was very confusing. Not to be used on ECM inputs, but ok, we use it on the B+ and Gnd terminals...
Its an Oscilloscope, What good is it to use it on the B+ and Gnd terminals??? Just use a High Z DVM.
That xxxx that you cannot use it on ECM inputs because basically diagnosing ECM controlled cars requires
a scope to monitor the signals to and from the ECM.
Are you sure the manual says not to be used on ECM inputs??? I seen many many Scanner Danner videos
where he hooks an AESwave or similar portable scope to the ECM signal lines.
Its an Oscilloscope, What good is it to use it on the B+ and Gnd terminals??? Just use a High Z DVM.
That xxxx that you cannot use it on ECM inputs because basically diagnosing ECM controlled cars requires
a scope to monitor the signals to and from the ECM.
Are you sure the manual says not to be used on ECM inputs??? I seen many many Scanner Danner videos
where he hooks an AESwave or similar portable scope to the ECM signal lines.
Add New Comment